Sony VPD-MX10 - Manual (Page 32)

GB 32
Maintenance
4
Insert the new lamp all the way in until
it is securely in place. Tighten the
screws. Fold up the handle.
• Be careful not to touch the glass surface
of the lamp.
• The power will not turn on if the lamp is
not secured properly.
5
Close the lamp cover and tighten the
screws.
6
Turn the projector back over.
7
Connect the power cord and turn the
projector to standby mode.
8
Press the following keys on the
control panel in the following order
for less than five seconds each:
RESET,
<, ,, ENTER.
• Be sure to use the LMP-M130 Projector
Lamp for replacement. If you use lamps
other than LMP-M130, the projector may
cause a malfunction.
• Be sure to turn off the projector and unplug
the power cord before replacing the lamp.
• Do not put your hands into the lamp
replacement spot, or not fall any liquid or
object into it to avoid electrical shock or
fire.
Cleaning the ventilation holes
Remove dust from the outside of the
ventilation holes with a vacuum cleaner.
Notes
Notes