Sony VPD-MX10 - Manual (Page 10)

GB 10
Location and Function of Controls
1 I / 1 1 1 1 (on/standby) key
Turns on and off the projector when the
projector is in standby mode. The ON/
STANDBY indicator lights in green
when the power is turned on.
When turning off the power, press
the
I / 1 key twice following the
message on the screen, or press and hold
the key for about one second.
For details on steps for turning off the
power, see “To turn off the power” on
page 23.
2 APA (Auto Pixel Alignment) key
Adjusts a picture clearest automatically
while a signal is input from a computer.
3 INPUT key
Selects the input signal. Each time you
press the key, the input signal switches
as follows:
4 RESET key
Resets the value of an item back to its
factory preset value. This key functions
when the menu or a setting item is
displayed on the screen.
5 Arrow keys ( M M M M / m m m m / < < < < / , , , , )
Select the menu or to make various
adjustments.
6 ENTER key
Enters the settings of items in the menu
system.
7 MENU key
Displays the on-screen menu. Press
again to clear the menu.
8 Indicators
• LAMP/COVER: Lights up or flashes
under the following conditions:
– Lights up when the lamp has
reached the end of its life or
becomes a high temperature.
– Flashes when the lamp cover is not
secured firmly or the front cover is
kept closed and the lamp goes out.
• TEMP (Temperature)/FAN: Lights
up or flashes under the following
conditions:
– Lights up when temperature inside
the projector becomes unusually
high.
– Flashes when the fan is broken.
• POWER SAVING: Lights up when
the projector is in power saving mode.
When POWER SAVING in the SET
SETTING menu is set to ON, the
projector goes into power saving mode
if no signal is input for 10 minutes.
Although the lamp goes out, the
cooling fan keeps running. In power
saving mode, no keys function for the
first 60 seconds. The power saving
mode is canceled when a signal is
input or any key is pressed.
• ON/STANDBY: Lights up or flashes
under the following conditions:
– Lights in red when a AC power cord
is plugged into a wall outlet. Once in
standby mode, you can turn on the
projector with the
I / 1 key.
– Lights in green when the power is
turned on.
– Flashes in green while the cooling
fan runs after the power is turned off
with the
I / 1 key. The fan runs for
about 90 seconds after the power is
turned off.
The ON/STANDBY indicator
flashes quickly for the first 60
seconds. During this time, you
Control Panel
LAMP/COVER
MENU POWER
INPUT
APA RESET ENTER
TEMP/FAN POWERSAVING ON/STANDBY
INPUT A t INPUT B t MS t VIDEO t S VIDEO
t