beautypg.com

Maintenance, Replacing the lamp – Sony VPD-MX10 User Manual

Page 31

background image

31

GB

Maintenance

M

a

in

te

nan

ce

B

Maintenance

Maintenance

When the lamp has burnt out or dims, or
“Please replace the LAMP.” appears on the
screen, replace the lamp with a new one. Use
LMP-M130 Projector Lamp as the
replacement lamp. The lamp life varies
depending on conditions of use.

When replacing the lamp after using
the projector

Turn off the projector, then unplug the
power cord.
Wait for at least an hour for the lamp to cool.

The lamp becomes a high temperature after
turning off the projector with the

I

/ 1 key. If

you touch the lamp, you may scald your finger.
When you replace the lamp, wait for at least an
hour for the lamp to cool.

• If the lamp breaks, consult with qualified

Sony personnel.

• Pull out the lamp by holding the handle. If

you touch the lamp, you may be burned or
injured.

• When removing the lamp, make sure it

remains horizontal, then pull straight up. Do
not tilt the lamp. If you pull out the lamp
while tilted and if the lamp breaks, the pieces
may scatter, causing injury.

1

Place a protective sheet (cloth)
beneath the projector. Turn the
projector over so you can see its
underside.

Be sure that the projector is stable after
turning it over.

2

Open the lamp cover by loosening a
screw with the Phillips screwdriver
(supplied with the Projector Lamp).

For safety sake, do not loosen any other
screws.

3

Loosen the screws on the lamp unit
with the Phillips screwdriver. Pull out
the lamp unit by the handle.

Replacing the Lamp

Caution

Notes

Note

Note

Handle