Sharp Notevision XR-32X - Manual (Page 29)

25
Basic
Operation
Turning the Projector On/Off
On-screen display (confirmation message)
• When “Auto Restart” is set to “On”:
If the power cord is unplugged from the outlet
or the breaker switch is turned off when the
projector is on, then the projector automati-
cally turns on when the power cord is plugged
into the AC outlet or the breaker switch is
turned on. (See page
45 .)
• English is the factory default language. If you
want to change the on-screen display to an-
other language, change the language accord-
ing to the procedure on page
44 .
Info
Turning the Projector on
Note that the connections to external equip-
ment and power outlet should be done be-
fore performing the operations written be-
low. (See pages
21 to 24 .)
Remove the lens cap and press
STANDBY/ON
on the projector or ON
on the remote control.
• The power indicator illuminates green.
• After the lamp indicator illuminates, the projec-
tor is ready to start operation.
Note
• About the Lamp Indicator
The lamp indicator illuminates to indicate the sta-
tus of the lamp.
Green: The lamp is on.
Blinking in green: The lamp is warming up.
Red: The lamp is shut down abnormally
or the lamp should be replaced.
• When switching on the projector, a slight flicker-
ing of the image may be experienced within the
first minute after the lamp has been illuminated.
This is normal operation as the lamp’s control
circuitry is stabilising the lamp output character-
istics. It should not be regarded as faulty opera-
tion.
• If the projector is put into standby mode and
immediately turned on again, the lamp may take
some time to start projection.
• When System Lock is set, the keycode input box
appears. To cancel the keycode setting, input the
keycode that you have already set. See page
46
for details.
Turning the Power off (Putting
the Projector into Standby Mode)
Press STANDBY/ON on the projector or
STANDBY
on the remote control, then
press that button again while the confir-
mation message is displayed, to put the
projector into standby mode.
• The projector cannot be turned on while cool-
ing.
STANDBY
button
ON button
• Direct Power Off function:
You can unplug the power cord from the AC out-
let even if the cooling fan is still running.
Info
STANDBY/ON button
Lamp indicator
Power indicator