Connecting the projector to other equipment, Terminals on the projector, Connections – Sharp Notevision XR-32X User Manual

Page 25

Connections

Before connecting, ensure that the power cord of the projector is unplugged from the AC
outlet and turn off the equipment to be connected. After making all connections, turn on the
projector and then the other pieces of equipment. When connecting a computer, ensure that
it is the last equipment to be turned on after all the connections are made.

IMPORTANT:

Ensure that the appropriate input mode has been selected on the projector before
you turn on the connected equipment.

• For more details of connection and cables, refer to the operation manual of the connecting equipment.
• You may need other cables or connectors not listed below.

Connecting the Projector to Other Equipment

COMPUTER/
COMPONENT

DVI-D

Equipment

Computer

DVI digital

output

terminal

Cable

DVI Digital cable (commercially available)

Terminal on

connected equipment

Terminal on the

projector

RGB

output

terminal

RGB cable (supplied)

Terminals on the Projector

• See page

“Computer Compatibility Chart” for a list of computer signals compatible with the projec-

tor. Use with computer signals other than those listed may cause some of the functions to not work.

• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your near-

est Macintosh Dealer.

• Depending on the computer you are using, an image may not be projected unless the

computer’s external output port is switched on (e.g. Press “Fn” and “F5” keys simultaneously
when using a SHARP notebook computer). Refer to the specific instructions in your computer's
operation manual to enable your computer’s external output port.

Note

is only for XR-32X.

Example: Terminals of XR-32X