Sharp UP-3300 - Manual (Page 51)

48
■ PLU level shift (for direct PLUs)
This shift can double or triple the number of direct PLUs on your POS terminal without adding additional
direct PLU keys. You can use direct PLUs in ten levels by utilizing the PLU level shift keys
L1 thru L10 .
Level key shifts the PLU level from the other nine to the required level. (The normal level is the level 1.)
You must program your machine in the PGM mode to select one of the two PLU level shift modes —
automatic return mode* and lock shift mode** — and decide whether to allow PLU level shift in both the
REG and MGR modes or in the MGR mode alone.
* The automatic return mode automatically shifts the PLU level back to level 1 after touching a direct PLU
key or finalizing each transaction.
** The lock shift mode holds the current PLU level until a PLU level shift key is touched.
Automatic return mode (for PLU levels)
If your terminal has been programmed for PLU level in the automatic return mode, touch a desired PLU
level shift key before a numeric entry.
Procedure
Direct PLU (Finalization)
(Q’ty, )
Numeric entry
Direct PLU Return to level 1
(Q’ty, )
Numeric entry
L1
L10
L2
L10
(Returning every item entry)
(Returning every transaction)
X/QTY
X/QTY
NOTE
When you use the FF method, you need not touch the X/QTY key for multiplication entries.
Lock shift mode (for PLU levels)
If your terminal has been programmed for PLU level in the lock shift mode, touch a desired PLU level shift key
before a numeric entry.
Procedure
Direct PLU Stay in the current level
(Q’ty, )
Numeric entry
L1
L10
X/QTY
NOTE
• If you select the automatic return mode (Retuming every item entry), it is not necessary to use the L1
key on the keyboard.
• When you use the FF method, you need not touch the X/QTY key for multiplication entries.