beautypg.com

Drink dispenser – Sharp UP-3300 User Manual

Page 238

background image

235

14

Drink Dispenser

Your POS terminal can be connected with a drink dispenser.
The summary of drink dispenser operations is shown below.

The data such as GLU codes, clerk codes,
sort numbers and so on which are entered
at a drink dispenser is sent to the POS
terminal.

Received data is
overwritten to an
applicable GLU
code.

Drink dispenser

UP-3300

When an entry error is found, perform the following steps:

1.

Check the error by the drink dispenser misoperation file reading or drink dispenser error reading.

Drink dispenser misoperation file reading

REG or MGR mode

Clerk report

OP X/Z or X1/Z1 mode

If there is misoperation data when you take an individual or full clerk X/Z report, the machine
waits for selection of one of the following three commands (RETRY, ABORT and IGNORE)
through the keyboard.

1 RETRY:

attempts to retry the report issuing job.

2 ABORT:

cancels the report issuing job.

3 IGNORE:

issues the report, disregarding that there is misoperation data. In the case of
the Z report, misoperation data is also reset.

Drink dispenser error reading

X1/Z1 mode

2.

Correct the error with the drink dispenser correction in the REG or MGR mode.

The error which relates to GLU codes can be corrected. However, the error which relates to PLU
codes or clerk codes cannot be corrected with the drink dispenser correction.

Procedure to return from Off-line to On-line mode

Case 1:
The drink dispenser was set to Off-line only for a short term and there have been no change in GLU
occupations (same guests at the same table).
The data-buffer of the drink dispenser can be emptied by using the DD reset function (Z1 mode). The POS
terminal - drink dispenser line is automatically set to On-line by this function.

Case 2:
The drink dispenser was set to Off-line for a long term. Therefore, the use of the DD reset function is not
applicable because GLU occupations have been changed, meanwhile. Empty the drink dispenser data-
buffer at the drink dispenser directly and set the POS terminal - drink dispenser line to On-line manually.