Sun Microsystems SOLARIS 10 - Manual (Page 74)

Version 3.1-en Solaris 10 Container Guide - 3.1 5. Cookbooks Effective: 30/11/2009
The following commands allow information to be displayed depending on the zones:
Command Description
df(1M) -Z
displays the zone mounts
ifconfig(1M) zone
assigns a virtual IP address to a zone
-zone
gives a virtual IP address back to the global zone
-Z
executes the command for all interfaces in the zone
ipcs(1) -z
displays interprocess communication parameters of a zone
pgrep(1) -z
applies pgrep to processes in zone zoneid
poolstat(1M) Displays statistics of resource pools
prctl -i zoneid
Displays and modifies resource controls of zone processes
priocntl(1) -i zoneid
shows the scheduling parameters of the processes of a zone zoneid
prstat -z
displays the process statistics of the processes of
-Z
displays information on processes and zones together
ps(1) -o pid,...,zone
zone exists as a format field for configurable outputs
-z
displays only processes
-Z
displays the zone that the process belongs to
rcapstat(1) -z
displays statistics for capped zones
rctladm(1M) Display and modification of global settings for resource controls
Table 8: Commands used to display zone information
67