StarTech.com MATRIX SV3254DX4I - Manual (Page 24)

19
‘
Admin Functions
The Admin functions allow you to access all of the features you will need
to perform an initial configuration of the SVxx54DX4I.
Network Config
DHCP (Dynamic Host Configuration Protocol)
Automatic network configuration using DHCP is: Enabled/Disabled. This
feature applies only to the LAN port on the rear panel and is enabled by
default. When enabled, the unit will automatically configure itself with
an IP address when a DHCP server is present. When disabled, the LAN
port will use the values assigned to it in the IP Addresses and Routing
section described below.