Smart Technologies 600i3 - Manual (Page 53)

41 | CHAPTER 5 – REMOTELY MANAGING YOUR SMART BOARD 600I3 OR
SBD600I3 INTERACTIVE WHITEBOARD SYSTEM
Source Selection
The Source Selection control enables you to switch between input sources.
.
Video Control
The Video control enables you to switch between Video output related controls.
Command Response Powered Off
set input [target] input=[current] no
get input [current] input=[current] yes
Field Possible Values Description
target input =VGA1
=VGA2
=Composite
=S-Video
Enables you to select which
application you would like to
switch to
current input VGA1
VGA2
Composite
S-Video
None
Indicates the current selected
input
NOTE: The None value is a
non-selectable value that
appears when you enter a
“get input” command while
the projector is in idle mode.
Command Response Powered Off
get brightness [target] brightness=[current] no
get brightness brightness=[current] no
set contrast [target] contrast=[current] no
get contrast contrast=[current] no
Field Possible Values Description
target brightness +val
-val
=0 to 100
If you specify a + or - before
the value, the specified value
is added or subtracted from
the current value. If you
indicate a specific numerical
value, the brightness sets
directly to the number.