Silex technology WLAN MODULE SX-550 - Manual (Page 76)

Page 70 silex Console Commands
Part Number 40183-101
Command Description
Sample output:
SET IP PRObe [ENable | DIsable]
SET IP RARp Enables setting of default router and/or subnet mask based on RARP IP address
set
The default value is 0.
Sample output:
SET IP RARp nn
nn: 0=both 1=no subnet, 2=no router, 3=neither
SET IP REtry Enables or disables LPD retry on incomplete job
The default value is Disable.
Sample output:
SET IP REtry [ENable | DIsable]
SET IP ROuter Sets default router address
The default value is 0.0.0.0.
Sample output:
SET IP ROuter aa.bb.cc.dd
SET IP SUbnet Sets IP subnet mask
The default value is 0.0.0.0.
Sample output:
SET IP SUbnet aa.bb.cc.dd
SET IP TCP Enables or disables the raw TCP 9100 protocol
The default value is Enable.
Sample output:
SET IP TCP [ENable | DIsable]
SET IP TELnet Enables or disables Telnet protocol
The default value is Enable.
Sample output:
SET IP TELnet [ENable | DIsable]
SET IP TFTP Enables or disables TFTP protocol
The default value is Enable.
Sample output:
SET IP TFTP [ENable | DIsable ]
SET IP TImeout Sets TCP inactivity timeout.
If fast timeout is enabled, the timeout is calculated as seconds.
If fast timeout is disabled, the timeout is calculated as minutes.
The default value is 1 minute.
Sample output: