Philips Saeco ESPRESSO SG200E - Manual (Page 8)

8
English
CUP DISPENSER
suitable for cups with 70-71 mm dia. and for cups
with 73 mm dia. through an adequate release
ring.
BOILER HEATING ELEMENTS
armoured types:
from 1,000 Watt for coffee boiler
CONTAINER CAPACITY
Coffee beans 2.0 Kg
Instant coffee 0.6 Kg (instead of tea)
Granular milk 0.85 Kg
Chocolate 1.7 Kg (or 2.6)
Tea 2.0 Kg
Sugar 2.0 Kg
Cups 195
Stirrers 185
3 - SAFETY
STANDARDS
3.1 Foreword
In compliance with the Machine Directive 98/37/
EEC, Low Tension Directive 73/23/EEC and CE
Marking Directive 93/68/EEC, the Saeco
International Group has drawn up a technical file
on D.A. SG200 E vending machine at its plants,
acknowledging during the design phase the
regulations listed in the Declaration of Conformity
inside any vending machine.
3.2 General safety rules
Warning
- Before using the vending machine, read this
manual carefully.
- Installation and maintenance must only be
carried out by qualified technicians.
- For no reason whatsoever shall the operator
reach those parts of the machine that are
protected by guards requiring special
instruments for removal.
- Good knowledge and absolute respect, from
a technical point of view, of the safety
standards and danger warnings contained in
this manual, are imperative for installing,
using, servicing and maintaining the machine
in minimum minimum risk conditions.
Warning
Always disconnect the POWER CABLE before
servicing or cleaning the machine.
Under no circumstances neither service the
machine, nor remove safety guards before hot
parts have cooled down!
fig. 4
Data plate showing the minimum
and maximum water pressure