Siemens SCALANCE X-200 - Manual (Page 90)

Diagnostics over Industrial Ethernet
6.2 Web Based Management (WBM)
Figure 6-18 "Agent Event Configuration" Dialog
You can configure the reaction of the SCALANCE X-200 for the following events:
E-Mail List Box
Displays and allows you to set the events that would cause an E-mail to be sent.
Trap List Box
Displays and allows you to set the events that would cause an SNMP trap to be sent.
Cold/Warm Start Text Box
The SCALANCE X-200 was turned on or reset by the user.
Link Change Text Box
A port has failed or data traffic is being handled again over a port that had previously failed.
Authentication Failure Text Box
There was an SNMP access with a bad password or inadequate access rights.
Power Change Text Box
This event occurs only when the power supply line 1 and line 2 is monitored. It indicates that
there was a change to line 1 or line 2.
Fault State Change Text Box
The fault status has changed. The fault status can relate to the activated port monitoring, the
response of the signaling contact or the power supply monitoring.
Industrial Ethernet SCALANCE X-100 and SCALANCE X-200 Product Line
6-22
Commissioning Manual, 1,