Smeg SC041MFX - Manual (Page 31)

33
Instructions for the installer
14.3 Hob-oven connection
Once installed, the combined hob must be connected to the oven. Fit the
oven into the built-in installation opening, leaving enough room to carry out
the operations described below:
connect the yellow-green earth wire of the hob to the oven's earth terminal
A (see figure);
connect the hob connectors to the sockets provided on the top casing of
the oven. The colours and symbols of the connectors must correspond to
those on the oven sockets;
if the hob has a residual heat warning device connector, connect it to the
unused socket on the right-hand side.
At this point the oven can be completely built-in into the cabinet, taking
care to place the power supply cable along the best possible route and
ensuring that it is not touching hot parts.