Snapper 1691356 User Manual
Page 7
Figure
11.
A. Blower Housing
B. Arbor Cover
C. Hook
D. Clip
E.
F. Washer,
6
G. Washer.
6
H. Spacer
I. Lockwasher,
6
J. Nut.
K. Washer,
L. Washer,
M. Locknut,
N. Wing Nut
E
Figure 12.
A. Cup
B.
C.
Wing Nut
E. Locknut,
F. Carriage Bolt
1 3 .
Install the new baffle (A,
13) in deck on stone
guard using existing hardware. Hardware may be
installed with nut to inside or nut to outside.
7
Over Stone Guard
Figure 13.
A. Baffle B. Carriage Bolt C. Mower Discharge Opening
Install the blower assembly as follows.
a. Pivot
(B, figure II) away to expose the
arbor.
b. Align the notch (G, figure IO) with
bracket. Align spacer (C, figure
with
(C.
figure 8) on arbor bracket. Slide the assembly into
place as shown in Figure
while aligning front
notch between cup and wing nut
figure
Tighten wing nut.
c. Place mower in low cut position. Raise the flap
(A, figure
and install the blower drive belt(D)
in the top groove of the pulley(B). (Pivot
B.
figure I I. away to expose flap.)
d. Rotate the
figure I I) into place
and attach the hook (C) to the clip (D) on the
housing.
Figure 14.
A. Arbor Bracket
Figure 15.
A. Flap
B.
C. Belt,