Snapper 1687262 - Manual

1
Installation
Instructions
Tube and Latch Kit
Part No. 1687262
Note: Use these Instructions to supplement portions of
the Operator’s Manual for Twin Catcher 1694916. Keep
these Instructions for future reference.
INSTALLATION
1. Apply new ID Label (A, Figure 2) directly over exist-
ing product ID Label on channel assembly (B).
For 38” Regent Series Twin Catchers
Figure 1. Contents
Figure 2. Apply New ID Label
A. ID Label, 1695163, (New)
B. Channel Assembly
Kit Contents:
Ref. Part No. Qty. Description
1 1732735A 1 Seal Plate
2 1732799 1 Seal
3 1960404 6 Screw, Phillips,
#10-24 x 3/4
4 1933896 6 Nut, Nylock,
#10-24
5 1703769 1 Tube
6 1704603 1 Latch, Tube
7 1960185 1 Washer, Flat
8 1935048 1 Nut, 5/16-18
9 1960122 1 Capscrew,
5/16-18 x 3/4
Ref. Part No. Qty. Description
10 1919326 1 Lockwasher,
5/16
11 1731420 1 Label, ID,
1695163
12 1931338 5 Carriage Bolts,
5/16-18 x 1-3/4
13 1720452 2 Saddle Clamp
Ref. Part No. Qty. Description
14 1960686 6 Nut, Nyloc,
5/16-18
15 1733432A 1 Brace
16 1930591 1 Capscrew,
5-16 x 3/4
17 1733416A 1 Latch
This kit is for updating a 1694916 Twin Catcher to
a 1695163 Twin Catcher.
A
4
Before beginning any service work turn off the
PTO, set the parking brake, turn off the ignition,
and disconnect the spark plug wire(s).
WARNING
1
17 2
8
5
3 7
6
9
10
B
11
12
15
14
13
16