Snapper 1691356 - Manual (Page 5)

INSTALLATION BLOWER ASSEMBLY, 42” 48” MOWER
1. Remove the right-hand arbor cover (A, 7) by 4. Before installing arbor bracket figure remove
removing bolts, washers and in front that hold washer from underneath blade brake bracket (rear
cover to deck. Also, remove nut and washers that capscrew). Arbor bracket is same thickness as washer
rear tab to arbor. and will replace washer.
2. Slip mower belt off the right hand pulley. Remove
the pulley from the arbor by removing and
washers. Save washers for re-installation. Use wood
block to prevent blade from turning
Figure 7.
A. Arbor Cover Nut Cover
3 . Remove brake spring or spring anchor (if equipped)
and two self-tapping screws from arbor. Install two
capscrews (A, figure 8).
Figure 8.
A. Capscrews
B. Arbor
Bracket
C. Notch
Arbor Pulley
E. Belt Stop. Front
Figure Arbor Bracket and Belt Stop
A. Arbor Bracket
B. Belt stop E. Large Washer
c . F. Lockwasher
spacer G. Nut
5. Install, the arbor bracket (A, figure and rear belt
stop Note thedifferent
and 48” mowers. Tighten snug only-belt stop
will be adjusted in step 8.
6.
installed in step 3) as shown. If
removed, reinstall brake spring spring anchor (F)
before flange nut(G). Tighten nut(E) snug only-belt
stop will be adjusted in step 8.
G Mower Decks
Blade
Brake
- - - - - -
Figure Front Belt Stop
A. Belt Stop
B . N u t
C. Large Washer F. Spring Spring Anchor
D. Lockwasher G. Locknut