Samsung SIR-S300W - Manual (Page 44)

Chapter 2: Setting up and connecting
37
1
Press the MENU button on your remote control.
The Main menu appears.
2 Use the arrow buttons on your
remote control to highlight the
SETUP
menu item, then press the
button on your remote control.
The SETUP menu appears.
3 Use the arrow buttons on your
remote control to highlight the
System
menu item, then press the
button on your remote control.
The System menu appears.
4 Use the arrow buttons on your
remote control to highlight the
System Test
menu item, then
press the button on your
remote control.
The System Test screen appears.
The test will begin as soon as the screen appears. Results are displayed in a
moment.
If the test discovers a problem with the satellite tuning, check that the satellite
dish is pointed properly, and that nothing is obstructing the direct view to the
satellite (over time trees can grow enough to block a previously open view).
If the test discovers a problem with the Access Card, check that the card is
properly inserted. (See Inserting the Access Card in Chapter 1 for details.)
The test shows the Receiver ID.
For problems with the phone line connection, be sure that the DIRECTV
Receiver is connected to a phone line, and that the phone line is working. (Try
plugging a telephone into the line you are using for the DIRECTV Receiver;
check to see if the phone gets a dial tone. If so, the line is working.)
5 When you have finished the system test, you can run the test again using the
on-screen Test Again button, exit the Menu system by pressing the EXIT button
on your remote control, or use the arrow keys to highlight on-screen Back
button, then press the
button to return to the System menu.