Samsung SIR-S300W - Manual (Page 43)

Chapter 2: Setting up and connecting
36
4
Use the arrow buttons on your remote control to highlight the Set Dish menu
item, then press the button on your remote control.
The Set Dish menu appears.
5 Use the arrow buttons on your
remote control to highlight the Auto
Detection
menu item, then press the
button on your remote control.
The Auto Detection screen appears.
The DIRECTV Receiver starts
attempting to identify the dish type.
You can stop the detection process
by using the arrow buttons on your
remote control to highlight the on-
screen Cancel button, then press the
button on your remote control.
Once the dish type has been
identified, a screen appears telling
you what type of satellite dish you
have.
6 To accept the detected dish type
setting, use the arrow buttons on
your remote control to highlight
the on-screen Back button,
then press the
button on your
remote control.
Testing the DIRECTV Receiver
The System Test feature allows you to quickly check the status of the satellite signal,
your Access Card, and your phone line connection. This is helpful in troubleshooting
should you experience problems with your DIRECTV Receiver.
To start the System Test, follow these steps: