Seiko Group SII IP-6600 - Manual (Page 110)

2-66
Pour the waste ink into the proper container you prepared and make
the waste ink bottle empty.
Enter to the “ADJUST” menu and select “TEST PRINT” on the
operation panel. (See page 3-44.)
Check no print dot-off and missing.
Perform the test print as the 1st time print on every day and especially
after cap cleaning for head cleaning.
When the print dot-off occurs at test print, perform slight head cleaning
in the “CLEANING” menu. (See page 2-42.)
Enter to the “CLEANING” menu and select “SLIGHT” on the
operation panel. (See page 2-42.)
- Do not leave the head carriage at the position other than
on the capping unit for a long time (more than 5 minutes).
- Perform the soft head cleaning after completion of the test
print.
NOTE