Sun Microsystems SUN FIRE X2100 - Manual (Page 26)

1-16 Sun Fire X2100 Server Getting Started Guide • April 2006
8. Position the cable hangers in the appropriate mounting holes in the CMA and
snap them into place. (See FIGURE 1-13 .)
For best results, place three hangers, evenly spaced, on the rear-facing side of the
CMA, and three on the side facing the server.
FIGURE 1-13 Installing CMA Cable Hangers
1.4.6 Attaching and Routing Cables
Use this procedure to attach cables to your server and route them through the CMA.
1. Install cables to your server, as required.
Refer to Section 1.5, “Cabling the Server” on page 1-17 for an illustration of the
server back panel ports and a procedure for installing cables to your server.
2. Route the cables through the CMA cable hangers.
CMA arm
CMA cable hanger