Sun Microsystems SUN FIRE X2100 - Manual (Page 15)

Chapter 1 System Setup 1-5
1.4.1 Disassembling the Slide-Rails Before Installation
Use this procedure to remove the mounting brackets from the slide-rail assemblies.
1. Unpack the slide-rails.
2. Locate the slide-rail lock at the front of one of the slide-rail assemblies, as shown
in FIGURE 1-2 .
3. Squeeze and hold the tabs at the top and bottom of the lock while you pull the
mounting bracket out of the slide-rail assembly, until it reaches the stop. See
FIGURE 1-2 .
4. Pull the mounting bracket release button toward the front of the mounting
bracket, as shown in FIGURE 1-2 , and simultaneously withdraw the mounting
bracket from the slide-rail assembly.
5. Repeat for the remaining slide-rail assembly.
FIGURE 1-2 Disassembling the Slide-Rail Before Installation
Slide-rail lock Mounting bracket
release button