Sharp AR-650 User Manual

Page 63

USING THE

EDITING

FUNCTIONS

Place the original(s) on the original feed

tray or on the glass.

When Using the Automatic Document Feeder

. After aligning the edges of the originals, set

them face up on the original feed tray and
align the slides to the edges of the originals.

Note: Remove any paper clips or staples from

the originals before placing them on the
original feed tray.

Slides

When Placing the Original on the Glass

. After lifting the automatic document feeder,

place the original on the glass face down with
the bottom toward you and the left side
centered against the original scale.

. Close the automatic document feeder slowly

after the original size has been detected.

Select the desired copy size, exposure,

reproduction ratio and copy quantity.

Press the START key.

Tip:

Edges can be erased also in the bypass
copy mode. To do this, set the paper in
the sheet bypass (see page 50), and press
the desired COPY-SIZE key to select the
paper size. If LETTER-R paper is used,
press the corresponding COPY-SIZE key
twice.