Sony RM-AV2100B - Manual (Page 42)

42
Transferring Data between Remote
Commanders (continued)
4
Press the 1 key.
1: All data of the Commander
2: Data of a Component Select button
5
Confirm that the receiving remote
commander is ready for data.
(To set the receiving commander,
follow the procedure on page 43.)
6
Press the “ENTER” key.
As the data is transferred, the
corresponding component name goes
off. If the all data has been
successfully transferred, the backlight
of the display turns off.
Note
If “NG” appears while sending the data, go
back to Step 5 and continue the operation
or press COMMANDER OFF to stop the
operation.
Notes
• The data of the functions or keys that are not
available with RM-VL900 cannot be
transferred. The data of a SYSTEM
CONTROL button cannot be transferred to
another kind of the Commander even if the
Commander has the
mark.
• Be sure that the receiving remote commander
is ready to receive data.
To transfer the data of a
Component Select button
The data of a Component Select button
on this Commander (the settings and
learned signals programmed on the keys
and buttons) can be transferred to a
Component Select button on another
Sony RM-AV2100 or RM-VL900.
1~3
Perform Steps 1 to 3 on page
41.
4
Press the 2 key.
5
Press the Component Select
button whose data you want to
send.
6
Confirm that the receiving remote
commander is ready to accept
data.
(To set the receiving commander,
follow the procedure on page 43.)