Sony RM-AV2100B - Manual (Page 29)

29
Notes
• You can program the System Control
functions for a Component Select button on
which the Power-On function (page 31) has
been programmed. In this case, the Power-On
function is overwritten and cannot be used. If
you clear the System Control functions for
the button, the Power-On function is
resumed, and you can use it again.
• You cannot program the System Control
functions for a Component Select button for
which a signal has been programmed by
“learning” (page 32). (“NG” flashes on the
display.)
• You can program a signal for a Component
Select button by “learning” (page 32) for
which the System Control functions have
been programmed. In this case, the System
Control function is overwritten and cannot be
used. If you clear the “learned” signal on the
button, the System Control function is
resumed and you can use it again.
• You can program the Power-On function
(page 31) for a Component Select button for
which a System Control function has been
programmed, but the Power-On function
cannot be used. If you clear the System
Control function from the button, you can
use the Power-On function.
• If you interrupt the procedure at any point
for over two minutes, the setting mode ends
and the series of commands will be
programmed to that point. In this case, clear
the program and start again from Step 1 to
set the entire program from the beginning.
You can not continue from where you let off.
•If you change the component code number
(page 8) or program a new signal by learning
(page 16) for a key or button that has been
programmed with the series of commands of
a System Control function, the new signal
will be transmitted when you press the
corresponding Component Select button.
To clear a System Control
function programmed for a
Components Select buttons
Example: To clear the programmed
commands on the VCR3 button
1
While pressing COMMANDER
OFF, press VOLUME+ and VCR3.
2
While pressing the RESET key,
press VCR3.
When the contents of its program are
cleared, all the component names
flash.
When you want to set a new program
to this Component Select button,
follow Steps 1 to 2 on page 28.
Continued