Sony RM-AV2100B - Manual (Page 37)

37
To reset a Component Select
button to its original setting
1 While pressing COMMANDER OFF,
press the Component Select button
which you want to reset.
2 While pressing the RESET key, press
that Component Select button again.
The setting for that Component Select
button returns to the factory setting.
3 Press COMMANDER OFF.
Note
If you have programmed some signals on any
of the keys or buttons with the learning
function (see page 16) after you reassigned
your component, the two steps above only
clears the “learned” signals. In this case,
perform Step 2 again to reset to the original
Component Select button.
To use the Commander after
assigning other components
Press the reassigned Component Select
button. The keys of the new component
are displayed and you can use the
desired component. Note however that
only the original component name is
displayed.
(In this example, the display would be
like the one below.)
Original component
name
Keys for operating
a CD player
Copying the settings of a
Component Select button to
another button
You can copy the entire settings of a
Component Select button to another
Component Select button. The settings of
the component code (page 8), the channel
macro function (page 45), and the learned
functions (page 16) are copied to a new
button.
Note
You cannot copy the settings to a Component
Select button for which any learning function
or channel macro function has been
programmed. (“NG” flashes.)
Continued