Sony RM-AV2100B - Manual (Page 34)

34
Turning Off the Power
of All Components with
the Touch of a Single
Button
— System Power-Off Function (for
Sony Components only)
When the System Power-Off function is
active, you can turn off all Sony
components just by pressing the
COMMANDER OFF button for three
seconds.
Notes
• Some Sony components may not be turned
off with this function.
• The power-off signals are transmitted at
intervals that are set for the System Control
function set for the SYSTEM CONTROL 1
button (page 30). If you change the interval
for the SYSTEM CONTROL 1 button, the
interval of the System Power-Off function is
also changed.
To set the System Power-Off
function
To clear the learned function of
the Component Select button
1 While pressing COMMANDER OFF,
press CHANNEL+ and VOLUME+.
2 While pressing the RESET key, press
the Component Select button which
you want to clear.
Notes
• You can program a signal by “learning” for a
Component Select button for which a System
Control function (page 28) or the Power-On
function (page 31) has been programmed. In
this case, the System Control function or the
Power-On function is overwritten and cannot
be used. If you clear the “learned” signal
from the button, the System Control function
or the Power-On function is resumed, and
you can use it again.
• You cannot program a System Control
function (page 28) for a Component Select
button for which a signal has been
programmed by “learning.”
• You can program the Power-On function for
a Component Select button for which a signal
has been programmed by “learning,” but
then the Power-On function cannot be used.
If you clear a “learned” signal from the
button, you can use the Power-On function.
Adding an Extra Function to the
Component Select Buttons
(continued)