Sony RM-AV2100B - Manual (Page 14)

14
Operating Your Components with
the Remote Commander
(continued)
To control the volume
Press the VOLUME +/– buttons to
control the volume, and the MUTING
button to mute. When you select a visual
component, the TV’s volume will be
controlled, and when you select an audio
component, the amplifier’s volume will
be controlled. You can change this setting
also (page 22).
Notes
• If you have programmed any signal for the
VOLUME or MUTING button for any
component using the learning function (page
16), that signal will be transmitted instead of
controlling the volume of the TV or amplifier
once you select that component.
• If you have programmed any signal for the
VOLUME or MUTING button of TV or AMP
using the learning function, that signal will
be transmitted only after you select TV or
AMP. When you select another components,
the preset volume control signals for TV or
AMP will be transmitted at that time.
• If you have assigned another component to
the TV or AMP button (page 35), the volume
of the TV or amplifier cannot be controlled
even when you select other components.
2
Press the desired key in the
touch-key display.
When the remote control signal is
sent,
is displayed on the display.
You may also use the VOLUME +/–
buttons, the MUTING button and the
CHANNEL +/– buttons if necessary.
See “Table of Preset Functions” (page
58) for the functions of keys and
buttons for each component.
3
When you are done using the
Commander, press
COMMANDER OFF to power off
the Commander.
Note
The remote control signals may be different for
some components or functions. In this case,
program the remote control signals with the
learning function (see page 16). Note, however,
that components and functions that do not
support the remote control of infrared signals
will not work with this Commander.