Sony DCR-IP5/IP7BT - Manual (Page 42)

42
Playing back a tape
Date/time Various settings
To clear the data code display
(1) Select OFF, then press the center z on the control button in step 4.
(2) Select EXIT, then press the center z on the control button. The data code
disappears from the screen.
When using the Remote Commander
Press DATA CODE on the Remote Commander in playback or playback pause mode.
The display changes as follows:
date/time t various settings (SteadyShot OFF, exposure, white balance, gain, shutter
speed, aperture value) t no indicator
To not display various settings while operating with the Remote Commander
Set DATA CODE via
to DATE in the menu settings (p. 102).
The display changes as follows each time you press DATA CODE on the Remote
Commander: date/time y no indicator
[a] SteadyShot OFF indicator
[b] Exposure mode indicator
[c] White balance indicator
[d] Gain indicator
[e] Shutter speed indicator
[f] Aperture value indicator
Various settings
Various settings is your camcorder’s information when you recorded. In recording
mode, the various settings are not displayed.
When you use the data code function, bars (-- -- --) appear if:
– A blank portion of the tape is being played back.
– The tape is unreadable due to tape damage or noise.
– The tape was recorded by a camcorder without the date and time set.
– The camcorder is in various playback modes.
Data code
When you connect your camcorder to a TV, the data code also appears on the TV
screen.
JUL 4 2002
12:05:56 PM
40min 0:00:23
60 AWB
F1.8 9dB
AUTO
40min 0:00:23
[a]
[b]
[c]
[d]
[e]
[f]