Samsung SINGLE LINE TELEPHONE - Manual (Page 25)

17
If you make an error, repeat the procedure with the correct code. Only the last account
code dialled will be recorded.
To enter an account code after the external party hangs up:
1. Press Recall, listen for confirmation tone and dial 47.
2. Dial the account code (a maximum of 12 characters, which can include # but not
*).
NOTE: If you wait for the external party to hang up, you must complete this procedure within 10
seconds. You cannot repeat the procedure if you make a mistake.
FORCED ACCOUNT CODES
The DCS system administrator can program individual extensions to prevent external calls
being made until an account code is entered. To make an external call in this case.
1. Lift the handset, wait for dial tone, and dial 47.
2. Dial the account code (a maximum of 12 characters–* and # are not allowed).
3. Press
the * key.
You hear confirmation tone followed by dial tone. An external call can now be made.
NOTE: Only one call can be made for each code entry—the above procedure must be used for each
call.
APPOINTMENT REMINDER/ALARM
This feature works like an alarm clock. Use it to remind yourself of an appointment later in
the day (TODAY ONLY) or as a daily reminder every day (DAILY). Depending on the
DCS system you are connected to, you can set either two or three alarms. Each one can be
either a TODAY ONLY or a DAILY alarm.
To set/reset alarms:
1. Lift the handset.
2. Dial
15 and then 112.
3. Dial the alarm number 1 or 2 (or 3 if available).
4. Dial the time you want the alarm to sound. Enter the time as HHMM (hours and
minutes) using a 24-hour clock format (e.g. 1300 for 1pm).
5. Dial 1 (TODAY ONLY) or 2 (DAILY) to select the alarm type.
6. Replace the handset.
7. Repeat for each alarm as required.
NOTE: If you hear an error tone at any time, replace the handset and start again from the beginning.
To cancel any alarm you have set, follow the above steps 1–3. Then, enter the time you set
for this alarm (HHMM), dial 0 and replace the handset.