Sun Microsystems PCI - Manual (Page 34)

12 Sun Dual Port 4x IB Host Channel Adapter PCI-X Installation and User’s Guide • September 2005
For example:
Refer to dmesg(1M) for more information.
2. Create the InfiniBand devices using the following command:
A /dev/ibdn device is created for each IB-HCA port in the system where n is the
port number. Refer to devfsadm(1M) for more information.
3. Verify InfiniBand devices.
Check that the InfiniBand devices were created. To do this, type the following
command:
A list of InfiniBand devices (/dev/ibd*) is displayed.
4. Plumb each of the IB devices.
To do this, type the following command for each IB-HCA port in the system:
where n is the instance number of the interface and host-ipv4-address is the designated
IPv4 address for the device.
If you are using IPv6, use the following command instead:
Dec 10 16:41:05 hostname pcplusmp: [ID 637496 kern.info] pcplusmp: pci15b3,5a44
(tavor) instance 0 vector 0x1c ioapic 0x4 intin 0x0 is bound to cpu 1
Dec 10 16:41:05 hostname pci_pci: [ID 370704 kern.info] PCI-device:
pci15b3,5a44@0, tavor0
Dec 10 16:41:05 hostname genunix: [ID 936769 kern.info] tavor0 is
/pci@0,0/pci1022,7450@b/pci15b3,5a46@1/pci15b3,5a44@0
Dec 10 16:41:05 hostname tavor: [ID 548581 kern.info] tavor0: FW ver:
0003.0002.0000, HW rev: a1
Dec 10 16:41:05 hostname tavor: [ID 827127 kern.info] tavor0: MT23108
InfiniHost Mellanox Technologies (0x0002c9010976bb40)
Dec 10 16:41:06 hostname tavor: [ID 979957 kern.info] NOTICE: tavor0:
port 1 up (link width: 4x)
# devfsadm -C
# ls -l /dev/ibd*
# ifconfig ibd n plumb host-ipv4-address up
# ifconfig ibd n inet6 plumb host-ipv6-address up