Sun Microsystems PCI - Manual (Page 31)

Chapter 2 Adapter Installation 9
This completes the hardware installation. Proceed to the verification instructions in
“Verifying the Installation” on page 9 .
FIGURE 2-1 Typical Adapter-to-Switch Configuration
▼ Verifying the Installation
Before you can verify the installation, you must install the adapter in the chassis,
power the server, and cable it to an operational InfiniBand switch. The InfiniBand
switch should automatically recognize InfiniBand servers when they are connected
to the fabric.
1. Check that the green LED is illuminated for each port that is connected to the
switch.
If the green LED is not on, check the cable connections at the adapter and at the
switch. Also check if the Tavor driver is attached to the port. See
“Troubleshooting
Tasks” on page 25 for details.
Sun 9-Port InfiniBand switch
Sun 9-Port InfiniBand switch
Sun server