Sun Microsystems Sun FastEthernet PCI Adapter 805-1759-10 - Manual (Page 25)

Chapter 3 Using the Sun FastEthernet PCI Adapter 13
Post-Installation Procedures (Optional)
Perform the tasks in the following sections to customize the performance of the Sun
FastEthernet PCI Adapter.
Configuring Driver Parameters
The hme device driver controls the SUNW,hme Ethernet device. The device driver
automatically selects the link speed using the auto-negotiation protocol with the link
partner. (See “Auto-Negotiation” on page 9.)
You can manually configure the hme device driver parameters to customize each
SUNW,hme device in your system in three ways:
■ Configure the hme driver parameters generally for all SUNW,hme devices in the
system by entering the parameter variables in the /etc/system file.
■ Set a parameter on a per-device basis by creating the hme.conf file in the
/kernel/drv directory.
■ Use the ndd(1M) utility to temporarily change a parameter. This change is lost
when you reboot the system.
Refer to the Platform Notes: The hme Fast Ethernet Device Driver document for more
information on configuring driver parameters. This document is also available on
the Solaris AnswerBook.
Increasing TCP/IP Performance
You can increase the TCP/IP performance of the Sun FastEthernet PCI Adapter by
changing the TCP highwater mark to 64K. This can be done with the
ndd(1M)
utility as shown in the following procedure.