Sun Microsystems Sun FastEthernet PCI Adapter 805-1759-10 - Manual (Page 22)

10 Sun FastEthernet PCI Adapter Installation and User’s Guide • July 1997
Monitoring Network Activity
Perform the following task to verify that the system recognizes the Ethernet
connection. Make sure that you are connected to an active network.
● To monitor network activity or incoming network packets, type the following at
the
ok promp:
Note – In the example above, hme interface> is the full path name
of the hme interface. Use the show-devs command at the ok prompt to display the
full path name of the hme device.
Rebooting the System
After you have examined the network activity, perform a reconfiguration boot on
your system so the operating environment can recognize the Sun FastEthernet PCI
Adapter.
● Perform a reconfiguration boot on the system.
Refer to the Solaris 2.x Peripheral’s Handbook for more information.
ok apply watch-net hme interface>
Internal loopback test -- succeeded.
Transceiver check -- passed.
Looking for Ethernet Packets.
‘.’ is a Good Packet. ‘X’ is a Bad Packet.
Type any key to stop.
............................................
ok boot -r