Sony XC-HR300 - Manual (Page 11)

11
Mode Setting
Restart/Reset
To set Restart/Reset mode
The information on one screen can be extracted at any
time by externally inputting a restart/reset signal (HD/
VD). To enter this mode, set the Restart reset/ External
trigger shutter mode switch on the rear panel of the
camera as shown in the figure below. The setting is
especially effective for the following operation.
EXT-VD
VIDEO OUT1,2
CCD accumulation
EXT-HD
Sample input timing chart
A highly-sensitive image is obtained by extending the
exposure time of the CCD when satisfactory sensitivity
cannot be obtained under other operating conditions.
Extend the VD interval (T) period between external
VD pulses.
Long exposure