Sharp SD-PX2 - Manual (Page 38)

E-33
ENGLISH
SD-PX2
Radio Operation
- Lis
te
ning
t
o
the
ra
dio -
Listening to the radio
Volume control (See page 16).
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the "STEREO" indicator.
z " " will appear when an FM broadcast is in stereo.
z If the FM reception is weak, press the TUNER (BAND) button to extinguish the
"STEREO" indicator. The reception changes to mono, and the sound becomes
clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
1
Turn on the power and press the TUNER (BAND) button to set the
input to "FM (AM)".
2
Press the TUNER (BAND) button repeatedly to select the desired
frequency band.
3
Press the TUNING ( or ) button to tune in to the desired station.
Manual tuning:
Press the TUNING button as many times as required to tune in to the desired
station.
Auto tuning:
When the TUNING button is pressed for 0.5 seconds or more, scanning will start
automatically and the tuner will stop at the first receivable broadcast station.
z When radio interference occurs, auto scan tuning may stop automatically.
Should this happen, tune in manually.
z Auto scan tuning will skip weak signal stations.
z To stop the auto tuning, press the TUNING button again.
FM stereo mode indicator
FM stereo receiving indicator
STEREO
FM stereo FM mono AM