beautypg.com

Antenna connection, Connecting speaker wires, E-12 – Sharp SD-PX2 User Manual

Page 17

background image

E-12

ENGLISH

SD-PX2

Preparation f

o

r Use

- S

p

e

ake

r connec

ti

o

n

/ Antenna c

o

nne

ction

-

„

Connecting speaker wires

z

Make sure to leave the AC power cord disconnected when connecting the
speakers.

z

Connect the speaker wires to the speakers first, then to the unit.

Caution:

z

Use a speaker system which has 35 W or more rated power input and 4 ohm
impedance.

z

If the volume is turned up too high with the speakers of less than 4 ohm imped-
ance connected, the protection circuit of the amplifier is activated. No sound is
produced temporarily.

z

Do not mistake the and , and right and left terminals of the speaker wires. (The
right speaker is placed on the right when you face the unit.)

z

When the center and surround speakers and subwoofer are not connected, set the
speaker size to "C-NO", "S-NO" and "SW-NO". Otherwise, the protection circuit
may be activated and the power is turned off.

Antenna connection

Note:

Placing the antenna on the unit or near the AC power cord may cause noise pickup.
Place the antenna away from the unit for better reception.

Installing the AM loop antenna:

Outdoor FM or AM antenna:

Use an outdoor FM or AM antenna if you require better reception. Consult your
dealer.
When using an outdoor AM antenna, be sure to keep the wire of the AM loop antenna
connected.

z

Do not short-circuit the speaker wire. If it happens with the
power on, the protection circuit is activated and the unit is
set to the power stand-by mode. In this case, check that the
speaker wire is connected correctly before turning on the
power again.

Incorrect

Supplied FM antenna:

Connect the FM antenna wire to the FM 75
OHMS jack and position the FM antenna wire in
the direction where the strongest signal can be
received.

Supplied AM loop antenna:

Connect the AM loop antenna wire to the AM
and GND terminals. Position the AM loop anten-
na for optimum reception. Place the AM loop an-
tenna on a shelf, etc., or attach it to a stand or a
wall with screws (not supplied).

< Assembling >

< Attaching to the wall >

Wall

Screws

(not

supplied)

White

Black

FM antenna

AM loop

antenna

Outdoor FM antenna

Outdoor AM antenna
49 feet (15 m)

25 feet (7.5 m)

AM loop
antenna

Ground wire

Ground rod