Sharp SD-PX2 - Manual (Page 15)

E-10
ENGLISH
SD-PX2
Preparation f
o
r Use
- S
yst
em
inst
alla
ti
on -
System installation
„ Placing the speaker system
The best surround effect will be achieved by placing each speaker at the same
distance from the listening position.
It is recommended to arrange the speakers as shown below.
Notes:
z Place the TV halfway between the front speakers.
z It is recommended that the center speaker be placed near the television.
z Place the surround speakers at a position just above the height of your ears.
z The subwoofer vibrates while reproducing bass. Place it on a stable, sturdy sur-
face.
z The subwoofer reproduces bass. Place it anywhere you like.
„ Cooling fan
Caution:
z The unit will get warm while being used. Do not touch the warm areas of the unit
for prolonged periods to avoid damage to you.
z Protect the amplifier unit from damage. When it is activated, the sound switch is
turned off. In this case, set the unit to the stand-by mode and turn on again.
Note:
The default distance is set to 6 feet (2 m). If speakers cannot be placed at equal dis-
tances, refer to "Speaker delay setting" (see page 44).
Installation image:
Front
speaker (left)
Subwoofer
Front
speaker (right)
Surround
speaker (left)
Surround
speaker (right)
Default setting:
6 feet (2 m)
Center
speaker
This unit is fitted with a cooling fan at the rear for improved cooling. Do not cover the
opening in this section with any obstacles.
Cooling fan
Front speaker (left) Front speaker (right)
Center speaker