Smeg CE6GPXU - Manual (Page 27)

Instructions for the installer
59
15.4.2 Connection to LPG
Both the pressure regulator and the connection to the cylinder must be standards-compliant. make sure
that the feed pressure complies with the values indicated in the table at point “16.2 Burner and nozzle
characteristics table”.
Screw the small hose connector F onto the large hose connector A; connect
the block this makes to the gas connector B (or use the hose connector G
which must be connected directly to the gas connector B) and place the seal
Cbetween them. Push the end of the rubber hose H onto the hose connector
A+F (or G) and at the outlet connector of the pressure reducer onto the
cylinder. Fix the end of the hose H to the hose connector A+F (or G) with the
standards-compliant clamp I
The hose connector A-F-G illustrated are not supplied with the appliance. Only use standards-compliant
hose connectors.
15.4.3 Connection with flexible steel hose (for all types of gas)
This type of connection can be made on both built-in and free-standing
appliances. Only use standards-compliant steel hoses whose length is not
greater than 2 metres.
Screw the end of the flexible hose L to the ½” OD threaded gas connector
(ISO 228-1) B placing the seal C between them.
At the end of the installation, check for any leaks with a soapy solution, never
with a flame.