Sun Microsystems SG-XPCIE1FC-EM8-Z - Manual (Page 49)

Chapter 2 Hardware Installation and Removal 23
Replacing the SFP+ Unit on the HBA
The Small Form Factor Pluggable (SFP+) optics unit on this card is considered a part
of the card, NOT as a separate field replaceable unit (FRU). Therefore, in the event
that the SFP+ unit malfunctions, you must return the entire card in order to receive
a replacement SFP+ unit. Always return any malfunctioning card with the SFP+ unit
attached. For information about removing the card from a system in order to return
it, see
“To Remove the HBA Hardware” on page 24 .
Removing the Hardware
The following procedures describe how to remove the HBA. Refer to your system
installation or service manual for detailed HBA adapter removal instructions.
The hardware removal process involves these general steps:
1. Halting the operating system and removing power from the server blade, or
computer.
2. Removing the HBA hardware.
▼ To Remove the HBA Hardware
1. Use an ESD strap (refer to “Observing ESD and Handling Precautions” on
page 9 ).
2. Refer to your system documentation to shut down, power off, and unplug the
system.
3. Disconnect all cables.
4. Unscrew the case screws and remove the system case.
5. Remove the mounting bracket of the HBA from the system by unscrewing the
panel screw or removing the clip, whichever is being used.
You can now remove the HBA.