SPT WA-1211S - Manual (Page 8)

7
AIR CONDITIONER FEATURES (CONTINUED)
SLEEP FEATURE:
DO THIS:
Press Sleep
button.
DO THIS:
Press Timer
button.
DO THIS:
Press Check
Filter button.
Display
TIMER: AUTO START/STOP FEATURE:
CHECK FILTER FEATURE:
DISPLAYS:
SLEEP feature:
When selected in conjunction with COOL mode:
Unit will operate at set temperature for 30 minutes.
After 30 minutes, unit will increase temperature by 2°F.
After another 30 minutes, unit will again increase
temperature by 2°F.
Unit will operate at the new temperature for 6 hours.
After 6 hours, unit will return to original setting and
continue to operate as originally programmed. This ends
the SLEEP feature.
SLEEP feature can be cancelled at any time during
operation by pressing the SLEEP button again.
TIMER feature:
Press the TIMER button to program Auto-Start or Auto-
Off. The corresponding indicator light will illuminate.
Use the UP/DOWN arrow buttons to program. Each
press is increment of 0.5 hours up to 10 hours, then in
increments of 1 hour up to 24 hours.
Unit will register timer setting after 5 seconds. If unit is
on, display will revert back to previous temperature
setting. If unit is off, there will be no display.
Turning the unit ON or OFF or adjusting the timer to 0
will cancel the timer program.
FILTER CHECK feature:
This feature is a reminder to clean the Air Filter for more
efficient operation. The LED light will illuminate after 250
hours of operation. Once the filter has been cleaned, press
the Check Filter button to reset.
DISPLAY:
COOL mode: displays set temperature in °C or °F and
timer.
FAN mode: displays ambient temperature
Error Codes:
“AS” = room temperature sensor error. Disconnect unit
from power source, wait 3 minutes and plug back in. If error
persists, call for service.
“ .” = evaporator temperature sensor error. Disconnect unit
from power source, wait 3 minutes and plug back in. If error
persists, call for service. (As shown in image to the left)