SPT WA-1211S - Manual (Page 16)

15
Location of the remote controller
Use the remote control within a distance of 5 meters (5.5 yards) from the
appliance, pointing toward the receiver. Reception is confirmed by a beep.
CAUTIONS
The air conditioner will not operate if curtains, doors or other materials block the
signals from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose the
remote controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the
air conditioner may not function properly. Use curtains to prevent the sunlight from
falling on the receiver.
If other electrical appliances react to the remote controller, either move these
appliances or consult your local dealer.
REPLACING BATTERIES
The remote controller is powered by tow AAA batteries (R03/LR03) housed in the rear and protected by a cover.
(1) Remove the cover by pressing and sliding off.
(2) Remove old batteries and insert new batteries – placing the (+) and (-) ends correctly.
(3) Replace cover by sliding it back into position.
NOTE: When batteries are removed, all programming are erased. After inserting new batteries, the remote controller
must be reprogrammed.
REMOTE CONTROLLER SPECIFICATIONS
Rated Voltage 3.0V (Dry batteries Lr03x2)
Lowest Voltage of CPU Emitting Signal 2.4V
Signal Receiving Range 5m
Environment -5°C ~ 60°C (23°F ~ 140°F)
Note: All illustrations are for explanation purposes only. The actual shape of remote may be slightly different.
HANDLING THE REMOTE CONTROLLER