SPT WA-1211S - Manual (Page 10)

9
Your air conditioner is designed install in standard double hung windows with opening widths of 23 to 36 inches
(584mm to 914mm) (See Fig.1)
Lower sash must have sufficient vertical opening for installation (Table
1). Side and rear of unit needs to be clear of obstacles to allow airflow
through condenser. The rear of the unit must be outdoors, not inside a
building or garage.
Table 1
Model WA-6011S/WA-8011S WA-1011S/WA-1211S
Minimum vertical
opening
14” (356mm) 15-1/2” (394mm)
NOTE: Save carton and these installation instructions for future
reference. The carton is the best way to store unit during winter, or when
not in use.
TOOLS NEEDED:
Phillips screwdriver
Drill (if pilot holes are needed)
CAUTION: When handling unit, be careful to avoid cuts from sharp
metal edges and aluminum fins on front and rear coils.
NOTE: The top rail hardware and the following Fig.A, Fig.B and Fig.C
are not applicable to the units more than 10000Btu/h.
Before installing unit, the top rail must be assembled:
(WA-6011S and WA-8011S only)
Tool Needed: Phillips Screwdriver
A. Remove unit from packaging and place on a flat surface.
B. Remove the top rail from rear of the packaging material. (Fig.A)
C. Align screw openings on the top rail to those on the top of the unit.
(Fig.B)
D. Secure top rail to unit with supplied 3/8” screws (Fig.C)
NOTES: For safety reasons, all four (4) screws MUST be securely
fastened.