SPT WA-1211S - Manual (Page 18)

17
Cooling and Fan Operation
Ensure the unit is plugged in and power is available.
4. Press the ON/OFF button to start the air conditioner.
5. Press the MODE button to select COOL or FAN mode.
6. In COOL mode, press the TEMP UP/DOWN button to set desired
temperature. Temperature can be set within the range of
17~30°C/62~86°F in 1°C/1°F increments.
7. Press FAN button to select fan speed in four steps: Auto, Low, Med,
or High.
NOTE
In Fan mode, temperature setting is not available, only steps 1, 2 and 4
may be performed.
Please refer to page 6 for details on AUTO and COOL setting.
Dehumidifying Operation
Ensure the unit is plugged in and power is available.
1. Press the ON/OFF button to start the air conditioner.
2. Press the MODE button to select DRY mode.
3. Press the TEMP UP/DOWN button to set desired temperature.
Temperature can be set within the range of 17~30°C/ 62~86°F in
1°C/1°F increments.
NOTE
In Dry mode, fan speed cannot be selected.
Sleep Operation
1. Press this button to activate the Sleep mode. This function is available
in COOL or AUTO modes only and will maintain the most comfortable
temperature for you.
2. In this mode, unit will run at your set temperature for 30 minutes. After
the initial 30 minutes, unit will increase set temperature by 1°C/2°F.
After another 30 minutes, unit will again increase temperature by
1°C/2°F. Unit will then maintain this new temperatu re for 6 hours and
return to original temperature setting. This ends the Sleep mode.
NOTE
Sleep mode is cancelled when any of these buttons are pressed: MODE,
ON/OFF, FAN SPEED and SLEEP.