Southbend 6" x 18" SURFACE GRINDER SB1029 - Manual (Page 11)

PREPARATION
For Machines Mfg. Since 8/09 Model SB1029
-9-
P R E P A R A T I O N
Preparation Overview Things You'll Need
During the setup process, operation, and
maintenance of your machine, you'll need the
following items:
For Lifting
s A forklift or other power lifting device rated
for the weight of the machine.
s ,IFTING
For Power Connection
s !
s !
For Assembly
s Another Person
s Cotton Rags
s Mineral Spirits
s 3AFETY
s Wrench 19mm
s Oil Can Filled with Oil Listed in
Maintenance
The list below outlines the basic process to follow
to prepare your machine for operation. Specific
steps for each of these points will be covered in
detail later in this section.
The typical preparation process is as follows:
1. Unpack the machine and inventory the
contents of the box/crate.
2. Clean the machine and its components.
3. Identify an acceptable location for the
machine and move it to that location.
4. Level the machine and either bolt it to the
floor or place it on mounts.
5. Finish assembling the machine by
installing the necessary components from
the inventory, and make any necessary
adjustments or inspections to ensure the
machine is ready for operation.
6. Connect the machine to the power source.
7. Test run the machine to make sure it
functions properly and is ready for operation.