Savin F ax Machine 1018 - Manual (Page 158)

Changing Key Operator Settings
75
6
Changing the User Parameters
• We recommend that you print the
User Parameter list and keep it
when you register or change a user
parameter. See P.76 “Printing the
User Parameter List”.
• Do not change any bit switches
other than those shown on the pre-
vious pages.
A
Press the
{{{{User Tools}}}} key.
B
Press
0 0 0 0 or 1 1 1 1 until "4. Fax Fea-
tures" is displayed.
C
Press the
{{{{OK}}}} key.
D
Press
0 0 0 0 or 1 1 1 1 until "6. Key Op.
Tools" is displayed.
E
Press the
{{{{OK}}}} key.
Note
❒ If the key operator code is regis-
tered and turned on, enter the
key operator code and press the
{OK} key.
F
Press
0 0 0 0 or 1 1 1 1 until "4. User Pa-
rameters" is displayed.
G
Press the
{{{{OK}}}} key.
H
Press the
{{{{OK}}}} key.
For a list of the switches and set-
tings, see P.72 “User Parameter
List”.
Use the User Parameters table to
look up the number of the switch
that you want to change, and then
press the
0 or 1 key to display
the number of the switch.
The switch bits are numbered 7~0.
To change a setting, press the cor-
responding number key to toggle
the setting between "0" and "1"
For example, if you want to change
the setting at bit 7, press the 7
number key to toggle the setting
between "1" and "0".
I
When you are finished making
adjustments, press the
{{{{OK}}}} key.
J
Press the
{{{{Cancel}}}} key on each
display until you reach the stand-
by display.
Key to
Press 7 6 5 4 3 2 1 0
SW 00: 0 0 0 0 0 0 0 0