Sanyo Xacti VPC-E2 - Manual (Page 48)

31
English
TURNING THE CAMERA ON AND OFF
Turning off the camera
1
Press the ON/OFF button for at least 1 second.
h The camera turns off.
h To turn off the camera while it is in the shooting mode or power save
mode, press the ON/OFF button for at least 1 second.
HINT
To immediately activate the power save
function
i Press the ON/OFF button briefly to
activate the power save function.
If the date and time setting has been
completed (page 32)...
i The current time is shown on the monitor
when the camera is turned on.
About the standby mode
i To turn off the camera only briefly, you
can close the monitor unit to put the
camera in the standby mode. The standby
mode uses almost no power. When the
monitor unit is opened again, the camera
turns on immediately and you are ready to
shoot or view images without any delay.
CAUTION
If the K icon appears...
i When a picture is taken, the date and time it was captured are recorded
with it. If the date and time settings have not been completed (page 32),
the date and time cannot be recorded with the captured images. For this
reason, immediately after the camera is turned on, the “Set date and time”
screen appears. To have the date and time recorded with the images,
please complete this setting before capturing images.