Samson MDR6 - Manual (Page 13)

11
ENGLISH
AUX RETURN LEFT/RIGHT
The AUX RETURN LEFT/RIGHT are stereo inputs that are generally used to connect the outputs of an effects proces-
sor, but can also accept the signal from any line level source like a keyboard, recorder and even another mixer. The
signal connected to he AUX RETURN LEFT/RIGHT will feed the main LEFT/RIGHT MIX bus. The overall level is con-
trolled by the AUX RET knob located in the master section on the front panel.
AUX Output
The signal present at the AUX output is sent from the AUX bus, which is fed from the AUX send on the input chan-
nels. The AUX output can be used as the MONITOR MIX bus in a live sound situation by connecting the output to a
power amp and monitor speaker.
CONTROL ROOM LEFT/RIGHT
The Control Room outputs are used to connect a studio monitor system. The Control Room outputs have the same
output as the L/R MIX, however, the level can be adjusted independently from the main mix using the C ROOM/
HEADPHONES control.
LEFT/RIGHT MIX
In a live sound application the LEFT/ RIGHT MIX outputs are connected to a power amplifier or powered speak-
ers. In a recording application, the LEFT/ RIGHT MIX outputs are used to connect a stereo device such as computer
sound card, DAT, or cassette recorder.
MONO OUTPUT
The Left and Right Mix outputs are summed together and sent to the MONO output. The level of the
Mono signal can be adjusted using the MONO OUT level control located just below the connector and
used to feed a speaker zone in a fixed installation.
MDR6 Input and Output Connections
EXTERNAL OUTPUT JACKS
The MDR6 features several output connectors allowing you to interface a variety of external devices. A stereo recording
device such as a cassette recorder can be connected to the 2 Track jacks, and additional power amplifiers can be con-
nected to the CONTROL ROOM and MAIN output jacks.
5
6
7
8
9