Hdd alarm, Using the dvr – Samsung SHR-8160 User Manual
Page 44
_
using the DVR
using the DVR
Select
Press
start formatting the selected device.
When the formatting is done, press
hdd alarm
You can set alarm settings for HDD defects such as Check Alarm Output Port, Replace Alarm Output Port,
and its duration.
Using the mouse may help easy setup.
Use the up/down buttons (▲▼) in
move to
Select
A window for setting HDD check and replace output ports
and their durations appears.
Use direction buttons (▲▼_ +) to move to the desired
item.
Alarm
- Alarm signal will output through the alarm out port on the
rear side when selected <1>, <2>, <3>, and <4>.
- If
- If
Check Alarm Output Port : If HDD generates check alarm, the alarm signal will output to the specifi ed alarm
output port.
Replace Alarm Output Port : If HDD generates replace alarm, the alarm signal will output to the specifi ed
alarm output port.
Duration: Sets the alarm duration for the alarm signal and beep sound.
- Check Alarm, Replace Alarm signals will output through the selected alarm out ports (1, 2, 3, and 4).
- If
- If
<
Check> status means that the HDD is operating but it has problems that require technical examination.
(
) appears on the Live screen.
<
Replace> status means that the HDD has defect and requires immediate replacement.
(
) appears on the Live screen.
When the HDD Alarm setup is done, press
.
.
.
.
.
~
~
~
~
M
`
`
.
Storage Device
Format
OK
Cancel
Device
HDD Alarm
Check Alarm Output Port
Duration
OFF
1
2
3
4
BEEP
All
Replace Alarm Output Port
Duration
OFF
1
2
3
4
BEEP
All
Storage Device
Device
OK
Cancel
HDD Alarm
Format
Device
Select
Used/Total
Usage
HDD
1
12.28G/499.37G
Internal
Format
Manage
Formatting deletes all recordings.
Proceed formatting?
OK
Cancel
00769B_SHR-8162_ENG-NEW.indb 44
2008-12-04 오전 10:15:26