Smeg CE92IPX - Manual (Page 29)

Instructions for the installer
61
16.INSTALLING THE APPLIANCE
The appliance must be installed by a qualified technician and according to the standards in force.
This appliance may be installed next to a wall which is higher than the appliance, with a minimum
distance of 5 cm from the side of the appliance, as shown in drawings A and B showing the correct
installation conditions. Any wall cupboards or shelves must be at a distance of at least 75 cm above the
work surface.
A) B)
Built-in appliance Free-standing appliance
16.1 Electrical connection
Make sure the voltage and the cross-section of the power cord match the specifications indicated on the
rating plated positioned in the storage compartment. Do not remove this plate for any reason.
If the appliance is connected to the supply by means of a fixed connection, install a multipolar cut-out
device on the line, with contact opening distance equal to or greater than 3 mm located near the
appliance and in an easily reachable position.
Connection to the supply may be fixed or with plug and socket. In the latter case the plug and socket
must be suitable for the cable employed and conform with the regulations in force. Regardless of the
type of connection, the appliance absolutely must be earthed. Before connection make sure that the
supply line is suitably earthed. Avoid the use of reducers, adapters or shunts which may cause
overheating.